Zebex Z-6070 Series Especificaciones descargar pdf (Pagina 12)

Verify the Scanning Operation

Before installing your Z-6070 scanner, please follow the

procedures below. This will lead to proceed for scanning

properly.

1. Connect the modular plug of the power link cable into the

back of the scanner.

2. Plug the DC plug of the power adaptor into the jack on

the power link cable.

3. Plug the AC end of the power adaptor into an AC outlet.

4. When the scanner powers up, LED lights in green and

the buzzer sound with 3-string-long-beep sound. When

the self-test is completed the LED status will return red.

5. Present the “test barcode” below to the scanner. If the

scanner is functioning properly, it will issue a short beep

and a green LED indicates a good read than remove the

“test barcode”

Note:

(1) If the scanner does not perform any or correct beep

sound, or without any LED indication when powers-up,

powers down the scanner and refer to Appendix B for

troubleshooting.

(2) If the initial interface of the scanner is in keyboard wedge,

and it only reads one barcode and remains with a green

LED indicating light, this is because the scanner is not

connected to a host terminal.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

Sin comentarios

Zebex Z-6070 Series Especificaciones Pagina 12