Zebex Z-6070 Series Especificaciones descargar pdf (Pagina 19)

Replacing the Interface Cable

The standard interface cable is attached to the scanner with

an 8-pin modular I/O-connector. When properly seated, the

connector is secured in the scanner handle by a flexible

retention tab. The cable is designed to be field replaceable,

Replacement cable can be obtained from ZEBEX, or an

authorized distributor.

To replace the cable, the following steps should be followed.

1.) Make sure that the power of your computer system is

switched off.

2.) Disconnect the scanner cable from the computer

system.

3.) Use a pin to press down the small hole situated at the

back of the scanner where the cable is attached.

4.) Straighten one end of paper clip.

5.) Pressure down the pin, and pull the connector out, the

cable is loosed.

Figure 9

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 38 39

Sin comentarios

Zebex Z-6070 Series Especificaciones Pagina 19